ThicknessThickness Command 2.1Sets the current 3D solid thickness. Goes to the plan view of the World Coordinate System. At the command line type in a name of a previously named Coordinate System. Goes to the plan view of the current UCS. Command: plan Enter an option : Regenerating model. Choose View, 3D Views, Plan View the one of the following: Current UCS, World UCS, Named UCS or 2. Choose View, 3D Views, and one of the following viewpoint options: Top, Bottom, Left, Right, Front, Back SW Isometric SE Isometric NW Isometric NE Isometric Vpoint PresetsResultant viewport with entered coordinates -1,-1,1 Command: vpoint Rotate/ : -1,-1,1 Regenerating drawing. Vpoint PresetsVpoint Command (Vector Option) 1.7Enters coordinates at the viewpoint prompt. Click OK.Resultant viewport with new 3D view Angle from the X Axis Pick a viewing angle in the 2 graphics Left graphic = From X Axis Right graphic = In XY Plane 5. Set a viewing angle by typing the From X axis and XY Plane angle. Choose View, 3D Views, Viewpoint Preset or 2. Command: vpoint Rotate/ : R (enter) Enter angle in XY plane from X axis : 225 (enter) Enter angle from XY plane : 15 (enter) Regenerating drawing.ДDVpoint Command 1.61. Vpoint Command (Rotate) 1.5Enters a rotation angle at the viewpoint prompt. Middle ring of the compass is the equator Click a point on the compass to define the viewing angle.Tripod Point in the center of the compass is the north pole The compass represents a two dimensional globe. Vpoint CommandVpoint Command (Tripod) 1.4Displays a compass and tripod for defining a view rotation. One of the following view options: Top Bottom Front Back Left Right Southwest Isometric Southeast Isometric Northeast Isometric Northwest Isometric Choose Click Click View, Named Views Orthographic & Isometric Views tab of the View dialog. OK.New Viewports tab of the Viewports dialog Choose Click Click View, Viewports, New Viewports the dropdown option for Setup and click 3D. NOTE: AutoCAD plots only the current vport. Click Type once in each vport to make it active. Command: -vports Enter an option : enter Enter a configuration option : enter Regenerating model. Screen divided into three tiled viewports AutoCAD is a registered trademark of Autodesk, Inc.

Autocad 3d learning pdf